September 4th, 2010 at 02:36am Under Uncategorized
First of all a female mould is constructed which is then coated with the layer of the gel coat . Later on, in that layer, layers of the fiberglass are coated that consists of the resins to provide the required thickness to the deck
By admin Continue Reading Improve your outdoor living with Virginia decks | Tallahassee Home …Add comment
August 23rd, 2010 at 09:09pm Under Uncategorized
Construction – Aramat with DSM gel coat . Certification – CE B www.otam.it. This entry was posted on Monday, August 23rd, 2010 at 23:09 and is filed under Boat
By admin Continue Reading New Model: Otam 58 Millennium Open | Boats WorldAdd comment
August 23rd, 2010 at 07:45pm Under Uncategorized
Careful do not over sand you have between 18 and 22 mills depending on how it was shot, a outside corner area on the deck is a inside in the mold and gets thicker gelcoat spray coverage, I would mix tool makers ink reduced 4:1 with …
By admin Continue Reading Gel Scratch Depth? – Offshoreonly.comAdd comment
August 23rd, 2010 at 07:29pm Under Uncategorized
Gel coat then lots of layer of chop strand matt. Heres the flange in all is glory! Now to make the bottom half. After sitting in its fibreglass tomb for two weeks the mould was opened revealing two halves, fins ‘n’ all! …
By admin Continue Reading We are if6was9: Hollow promisesAdd comment
August 12th, 2010 at 12:46am Under Uncategorized
There is no doubt summer is here, the blistering gel coat on your deck while poling the flats is an obvious sign. I however like to focus on our finny friends rather than the heat this time of year and submit to you this is a great time …
By admin Continue Reading Conservation Conversations | Coastal Angler Magazine Fishing ReportsAdd comment
August 3rd, 2010 at 08:11pm Under Uncategorized
Most use polyester and gelcoat and they think its good????I have done a couple but its not worth competing against the low ball guys out there. I do have a nephew who works for two different guys. Its the wood under the deck that can be …
By admin Continue Reading Fiberglass Decking (roof-top/balcony). – The Hull TruthAdd comment
July 10th, 2010 at 08:43pm Under Uncategorized
For several years the cdn built co26’s were made with too heavy a gel coat causing cracks in the deck surface. I would hazard to guess that if there are no/minimal cracks now then you should be ok, something to keep in mind.
By admin Continue Reading Contessa 26 – What do you think – SailNet CommunityAdd comment
June 17th, 2010 at 12:00pm Under Uncategorized
Well I was wrong, the project non-skid / gelcoat repair project hit a speed bump yesterday and they are not ready to begin masking off the deck to begin the refinish process. The hold-up was the cockpit sole.
By admin Continue Reading Non-Skid/Gelcoat Repair, Part 3 | www.boats.comAdd comment
May 29th, 2010 at 02:46pm Under Uncategorized
A worktable sits in the middle of the deck and is coated with a sanitary gel coat and coarse surface to help keep oil-covered birds from slipping on the surface and adding to their stress. “This whole disaster really got our ire up,” …
By admin Continue Reading Buffett Helping Boat Builder in Oil Spill Relief Effort | Jimmy …Add comment
May 23rd, 2010 at 06:43pm Under Uncategorized
However, the deck foam core is pretty much completely deteriorated in all places that I looked, although the top fiberglass skin and gel coat show almost no sign of stress or compression cracking.
By admin Continue Reading Looking For Opinion About Needed Restoration On Snipe I'm Looking …Add comment